The Ice-O-Matic ICE0520FW is a water-cooled Modular style ice machine that produces up to 527 pounds of full-sized Cube ice each day. The 22" wide cuber head is constructed from corrosion resistant stainless steel as well as fingerprint-proof plastic. The ICE0520FW is just over 23" tall, so this model takes up very little space.
The Ice-O-Matic ICE0520FW produces Full Cube ice that measures 7/8 inches by 7/8 inches by 7/8 inches. The larger-sized cube takes longer to melt and lasts a long time while cooling beverages, so there is less dilution of your drink. For installation, the ICE0520FW requires a 115 volt, 60 Hz, 1-Phase power supply. Since the ice machine is water-cooled, it needs two incoming water lines (one for ice-making and one to cool the condenser). The water-cooled unit does not require clearance on the sides for air intake and exhaust vents, since the water-cooled condenser does not require air circulation. Note that the water-cooled model does require an external drain for the 157 gallons of water used to cool the condenser for each 100 pounds of ice produced. However, the 22-inch wide design and no additional side clearance requirements means you can install the Ice-O-Matic ICE0520FW cuber head even if you have limited space (minimum of 22 inches left to right).
The Ice-O-Matic B42PS storage bin is also 22 inches wide and can hold up to 351 LB of ice. The B42PS storage bin measures 50" high with the adjustable legs set at 6". The exterior of the Ice-O-Matic B42PS corrosion-resistant stainless steel. It has an inner polyethylene bin liner. Between the interior and exterior is a layer of foam insulation. Ice-O-Matic has also included a built in ice scoop holder on the inner wall of the bin (ice scoop not included). At the back of the Ice-O-Matic B42PS there is a bin drain to allow any melted ice to drain out of the unit. You can utilize the same external drain for both the storage bin and the water-cooled ICE0520FW.
When the Ice-O-Matic ICE0520FW cuber head is mounted on the B42PS storage bin, together they measure just over 73" high. This ice machine and storage bin combo is ideal for locations where you have minimal wall space and your ceiling height is restricted (just over 6 feet floor to ceiling is required). Ice-O-Matic has also incorporated AgIon compound antimicrobial protection directly into the surfaces of the cuber head that come into contact with ice or water. With a production rate of 527 LB per day and a storage capacity of 351 LB, the ICE0520FW-B42PS ice machine and storage bin equipment combo allows you to make and store a moderate amount of ice, making it a good choice for business with moderate ice requirements and limited space.