The Ice-O-Matic ICE0400HA-B40PS is a 30" wide air-cooled ice machine with a production rate of approximately 505 pounds of half cube ice every 24 hours mounted on an ice storage bin.
The Ice-O-Matic ICE0400HA's cabinet is only 20" high. The ICE0400HA cuber head is an air-cooled unit, so it will require a minimum of 6" of air circulation clearance on the right side and the back for air intake and exhaust vents. The half cube ice produced by the Ice-O-Matic ICE0400HA measures 7/8" wide x 7/8" deep x 3/8" high. With its smaller size, half cube ice is suitable for dispensing applications, since it is less likely to jam the dispenser. The Ice-O-Matic ICE0400HA only requires a 115 volt electrical connection, a potable water line in, and a drain for purged, mineral-laden water at the end of each ice-making cycle, and is therefore easy to install. In addition, the Ice-O-Matic ICE0400HA uses Harvest-Assist technology to increase the speed of ice removal from the evaporator surface, thus shortening each ice-making cycle and saving you time and electricity.
The Ice-O-Matic B40PS storage bin is 30" wide like the ICE0400HA cuber head. The B40PS bin can hold up to 344 LB of ice. The storage bin is a total of 37.5" high by itself, including the adjustable 6" legs. Ice-O-Matic has designed the B40PS with a stainless steel exterior and a polyethylene bin liner. There is a layer of foam insulation between, to preserve your ice. The molded plastic bin door flips up for easy access to your supply of ice. The Ice-O-Matic B40PS has a bin drain located at the back of the unit to remove any standing water created by melting ice. The bin drain can use the same external drain as the cuber head.
With the low profile ICE0400HA ice machine cuber head sitting on top of the B40PS bin, the total height of the equipment combination is only 57.5" high. This makes the Ice-O-Matic ICE0400HA-B40PS cuber head and bin combo an optimal choice for locations with restricted installation space and with a moderate daily need for ice.