The Ice-O-Matic ICE0606HW-B40PS is a combination of the Ice-O-Matic ICE0606HW water-cooled full cube ice machine and the B40PS storage bin. The ICE0606HW is designed to be mounted on top of the B40PS bin.
The Ice-O-Matic ICE0606HW cuber head is only 20" tall and 30" wide. The ICE0606HW is capable of producing 618 pounds of Half Cube ice in a day (just under 26 pounds of ice every hour). The Half-Sized Cube produced by the ICE0606HW measures 7/8" x 7/8" x 3/8". The smaller Half Cube works well in dispensers because the cubes are less likely to jam the dispensing mechanism. Plus more Half Cube ice can fit in each glass, with higher liquid displacement there is less beverage per serving.
For installation, the Ice-O-Matic ICE0606HW requires a 208-230 volt electrical connection and 2 incoming water lines. One water line should be potable water for making the ice (19.5 gallons of water per 100 pounds of ice). The second water line is for cooling the condenser (an additional 140 gallons of water per 100 pounds of ice produced will be flushed). The Ice-O-Matic ICE0606HW therefore requires an external drain that can handle the high volume of water, since both purged water from each ice making cycle AND the condenser water must be drained. One benefit of a water-cooled ice machine is that there will be no hot air vented into the surrounding area. Also, water-cooled ice machines don't need any side air vent clearances, so the Ice-O-Matic ICE0606HW can be installed in narrow spaces such as between other equipment.
The Ice-O-Matic B40PS storage bin is also 30 inches wide. The bin has a storage capacity of up to 344 LB of ice. The Ice-O-Matic B40PS is constructed with a corrosion-resistant stainless steel exterior for durability and an easy-to-clean inner polyethylene liner for excellent sanitary conditions. Between the interior and exterior walls is a layer of foam insulation. The plastic bin door of the B40PS flips up and stays open so you can scoop your ice. Plus the B40PS bin has a built-in scoop holder so you never have to hunt for the scoop. Note: a bin drain is located at the back of the unit (the bin drain can use the same external drain as the cuber head).
With the cuber head sitting on top of the storage bin, the entire ICE0606HW-B40PS equipment combination measures only 57.5" high with the bin legs attached. With such compact dimensions, the Ice-O-Matic ICE0606HW-B40PS equipment combo would be a good investment for a business with a moderate daily ice usage (around 600 pounds of ice) and limited available space for installation.